Report any errors on this page in the comment box below.
PDF OCR Transcript: Weems & Plath® 214 Eastern Avenue • Annapolis, MD 21403 p (410) 263-6700 • f (410) 268-8713 www.Weems-Plath.com/OGM All Around (RED) LED Nav Lights (for Commercial & Military Vessels) USCG 2NM Approved 33 CFR 183.810 Meets ABYC-A16 Model: LXAA-RED OWNER’S MANUAL INTRODUCTION Weems & Plath’s OGM LX All Around (RED) LED Navigation Light is designed for power-driven commerical or military vessels and will provide full brightness at any operating voltage from 9V to 30V DC. This ensures the light will meet or exceed the visibility requirements as the battery voltage drops from use. To ensure compliance with the ‘72 COLREGS and U.S. Inland Rules, the installation instructions provided below must be followed. Mounting: 1. There are three 6-32 stainless steel inserts in the bottom of the light’s housing. This allows the All Around Light to be mounted to a variety of mounting brackets. *Mounting brackets can be purchased from Weems & Plath or your local marine retailer. 2. The light should be mounted level and even to insure maximum visibility of the light. Wiring: The All Around (RED) Light is equipped with a 3-conductor waterproof plug. The mating connector and 2-foot cable are included. Mast wiring of 20-gauge is sufficient to supply power to the light, although 16-gauge is recommended. There are three wires in the supplied mating yellow/black cable, however you will only use two wires for the All Around (RED) Light (#LXAA-RED). The proper connection for these wires is shown in the following diagram: Quick Disconnect Wiring Diagram BLACK (Shield) Ground Wire Color from Pigtail Connection/Function BLACK Electrical ground/negative battery terminal BROWN (NOT USED) BLUE Power for All Around Light 1. Connect the black wire to the boat’s DC ground and the blue wire to the boat’s DC positive power source. NOTE: DO NOT CONNECT THE BROWN WIRE. Ensure that the supplied voltage is greater than 8V and less than 31 V DC. Weems & Plath does not guarantee any light connected improperly or to an incorrect voltage. Always verify proper DC voltage before final connections are made. 2. WARNING: The current draw of the All Around Light is ≤ 0.33 Amps at 12V DC. The power circuit should include proper fusing or a circuit breaker with a trip current of 1 Amps. 3. Check the light with a battery after installation is complete to ensure proper operation. SPECIFICATIONS Visibility: 2 nautical miles Waterproof: yes, completely submersible Power Consumption: 6 Watts Voltage Range: 9V to 30V DC Current Draw: ≤ 0.33 Amps at 12V DC Wiring: 2-conductor 20 AWG UV jacketed 2-foot cable Horizontal Viewing Angle: 360° Vertical Viewing Angle: +/- 18° NOT USED BROWN (Black) BLUE (Red) All Around Warranty: This product is covered by a LIFETIME Warranty. For more details on the warranty, please visit: www.Weems-Plath.com/Support/Warranties Warranty: This product is covered by a LIFETIME Warranty. For more details on the warranty, please visit: www.Weems-Plath.com/Support/Warranties Warranty: This product is covered by a LIFETIME Warranty. For more details on the warranty, please visit: www.Weems-Plath.com/Support/Warranties To register your product visit: www.Weems-Plath.com/Product-Registration
FREE ENGLISH PDF
USER GUIDE - USER MANUAL
OWNER GUIDE - OWNER MANUAL
REFERENCE GUIDE - REFERENCE MANUAL
INSTRUCTION GUIDE - INSTRUCTION MANUAL