YAMAHA RX-V385 (02) PDF MANUAL


Post questions, comments, reviews or page errors in the comment box below.


PDF Content Summary: Manual Development Group AV19-0002 This guide explains how to update the firmware in the unit using a USB storage device. For information on the improvements and additional features introduced by the firmware update, refer to the product page for this unit on Yamaha’s website. Requirements for updating the firmware • Use a USB storage device that satisfies the following requirements: – Supports Mass Storage Class – Features FAT16 or FAT32 format – Does not feature the encryption function – Contains no data (content is empty) • Use the firmware data downloaded from Yamaha’s website. Preparing the firmware 1 Download the latest firmware for the unit from Yamaha’s website. For more information, refer to the product page for this unit on Yamaha’s website. 2 Expand file “000xxx-xxxx.bin” the downloaded to compressed the USB storage file, and device. then save the firmware data Save the file in a folder at the highest level of the hierarchy (root folder) on the USB storage device. Do not change the file name. EN © 2019 Yamaha Corporation Published 05/2019 YJ-A0 Update Guide Updating the unit’s firmware You can update the firmware using the front panel. NOTICE • Do not turn off the power to the unit during the update. Doing so may prevent the unit from starting up. 1 Press z (power) to turn the power off. 2 Insert the USB storage device into the USB jack. 3 While pressing and holding down STRAIGHT, press z (power). “ADVANCED SETUP” appears on the display. 4 Press PROGRAM to select “UPDATE · · · · USB”. 5 Press INFO (WPS). The firmware update starts. Do not turn off the power to the unit during the update. 6 When off the “UPDATE power to SUCCESS” the unit. appears on the display, press z (power) to turn 7 Remove the USB storage device from the USB jack. The firmware update is complete. NOTE • Wait about five seconds after the firmware update is complete, and then turn on the power to the unit. Viewing the firmware version You can view the firmware version after the update is complete. NOTICE • Do not turn off the power to the unit during the update. Doing so may prevent the unit from starting up. 1 Press z (power) to turn the power off. 2 While pressing and holding down STRAIGHT, press z (power). “ADVANCED SETUP” appears on the display. 3 Press PROGRAM to select “VERSION”. The firmware version is displayed. In case of an error If an error message appears on the display during the update operation, the firmware will not be updated correctly. Determine the cause, and try to update the firmware again. Cause Solution The USB storage device may not be properly connected to the USB jack. Make sure that the USB storage device is connected properly. Then try to update the firmware again. The firmware data file may not have been stored in the USB storage device properly. Make sure that the file has been stored in the folder on the highest hierarchy (root folder) of the USB storage device. The USB storage device may be protected by a password or other methods. Use a USB storage device that is not protected by a password or other method.

FREE ENGLISH PDF

OPERATING INSTRUCTIONS

USER GUIDE - USER MANUAL

OWNER GUIDE - OWNER MANUAL

REFERENCE GUIDE - REFERENCE MANUAL

INSTRUCTION GUIDE - INSTRUCTION MANUAL